Publicidad
14
14
52K
21S
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
Carefully stand your unit upright.
Set the ROD (P) onto the ROD HANGERS on the ENDS (A and B).
Fasten the DOOR (H) to the LEFT END (B). Use the screws in the HINGES.
NOTE: You may need to loosen the mounting screw to slide the HINGE slightly out of the slot. Retighten the screw before mounting
the HINGE to the END.
Fasten a PULL (52K) to the DOOR (H). Use a BLACK 1-1/8" MACHINE SCREW (21S).
Repeat this step for the other door.
415107
H
Mounting
screw
www.sauder.com/services
P
B
A
Page 19
Publicidad
