Publicidad
Idiomas disponibles
Idiomas disponibles
2. BEFORE INSTALLATION
2.1 Installation location
You must follow the instructions below:
> The floor on which the product is to be installed
must be capable of bearing 1,200 pounds (544 kg)
minimum.
> The kitchen floor and the bottom of the product
must be equally level. Otherwise, problems may
occur with the appliance's air flow.
> There must be no obstructions at the rear and on
the side walls of the product's installation location
that would prevent its installation.
> The electrical outlet must be in the correct place.
> The dimensions of the cabinet where the appliance
is to be installed must be in strict conformity with
the dimensions provided in the manual.
> Do not install the appliance adjacent to another
fridge/freezer.
Otherwise,
damage may occur. (Please see "Dual-Fridge
Cabinet Installation" for detailed information).
> The level of the floor where the product is to be
installed must be checked with a bubble level.
> The installation location must not be exposed
to direct sunlight and must be away from heat
sources (ovens, radiators, etc.).
> The ambient temperature must be between 50°F
(10°C) and 110°F (43°C). Otherwise, malfunctions
may occur when the appliance is running.
> If it is not possible to avoid installing the product
near a heat source, the minimum clearances
provided below must be maintained between the
appliance and the given source:
• 1 1/4" (32 mm) from electric ranges or ovens
• 12" (305 mm) from gas or fuel-powered kitchen
ranges or ovens
Please heed the following rules:
> The electrical outlet or panel must be easily
accessible in case of an emergency; it must not be
hidden behind the product.
> Neither the plug nor the cable may touch the
back surface of the appliance. Otherwise, it may be
damaged by the appliance's vibrations.
> Do not connect other equipment plugs behind
this appliance.
If the humidity level is high where the appliance
is being used, its exterior surfaces may become
corroded.
To prevent corrosion, keep the installation room
dry and well-cleaned.
condensation
and
To prevent the risk of electric shock:
> Connect the plug to a grounded 3-prong outlet.
> Do not remove plug's grounding prong.
> Do not use adapters.
> Do not use extension cords.
CAUTION:
Failure to follow these instructions may
result in fire, electric shock or death.
Connecting
the
conductor in the wrong place may lead to
electric shock. Please have the grounding
checked by a qualified electrician or service
technician if you have any doubt about the
proper grounding of the appliance.
Installation, repairs and other procedures
performed by unqualified persons may
give rise to hazards. Before installing the
appliance, make sure that the voltage, load
and circuit current parameters on the data
plate are in compliance with the power
supply in your house.
The appliance is provided with a NEMA 5-15
P plug and a 3-prong power cord which is
in the UL list and ready to be connected to a
120 V, 60 Hz power supply. Fuse is 15 A. The
appliance must be connected to a 3-prong
socket. The plug must be installed only by a
licensed electrician.
If the electrical wiring or the electric power
supply of the house requires alteration, the
necessary procedures must be performed
by a qualified electrician.
CAUTION:
Do not install your refrigerator:
• in an outdoor space,
• in a location with dripping water,
• in a location where the temperature is
lower than 50°F (10°C).
appliance's
grounding
7
EN
Publicidad
