Motorola Solutions CLR Serie Manual Del Usuario página 18

MN007428A01-AB
Chapter 2: Getting Started
TPT is selectable in the Customer Programming Software (CPS. The default is OFF.
NOTICE: To ensure your words are not cut off, always wait for the TPT before you start to
speak.
2.8
Menu Setting
Procedure:
1 To navigate through the menu settings, press the Menu button.
2 To exit the menu, short press the PTT button or wait for three seconds.
2.8.1
Operations Using Menu Settings
This section explains operations using the menu settings.
NOTICE:
It is not necessary to wait for the voice prompt to be completed before continuing with pressing
the next button.
If you are in the menu mode, short press PTT or wait 3 seconds to exit the menu.
Procedure:
1 Changing channel:
a Press Menu button to navigate to Channel.
b Press the (+) or the (-) button to change channel.
2 Entering Monitor Mode:
a Press Menu button to navigate to Monitor.
b Press the (+) to activate or the (-) button to deactivate monitor.
3 Entering Scan Mode:
a Press Menu button to navigate to Scan.
b Press the (+) to activate or the (-) button to deactivate scan.
4 Enabled through Customer Programming Software (CPS):
Sending Call Tone:
a Press Menu button to navigate to Call Tone.
b Press the (+) or the (-) button to send call tone.
5 Enabled through Customer Programming Software (CPS):
Long Press Menu button for 2s to access:
a Easy Access Call Tone.
b Escalate Call–Switch channel, announce, and send call tone.
18