Connecting The Power Cord - JVC EX-A1 Manual De Instrucciones

Connecting up
Connecting with TV
TV
Supplied composite video cord
CAUTION
Connect the main unit directly with a TV (or a
monitor) without routing through a VCR.
Otherwise it may cause picture distortion while
playing.
Main unit
Connecting directly
Also, when connecting the main unit to a TV with
a VCR built in, there may be picture distortion
while playing.
NOTE
Please check that the setting for VIDEO OUT SELECT
(PAL / NTSC) on the rear panel of the main unit and
the color system on your TV set are the same.
A
( page 5)
When a clearer picture is
desired
You can enjoy pictures of better quality using the
following cord instead of the supplied video cord.
Connecting by using the S-Video cord
TV
S-Video cord
(sold separately)
Connecting by using the component video
cord
You can enjoy better quality pictures than when
Main unit
using the S-Video cord.
TV (or
monitor)
CAUTION
Use one of either the S-Video cord or the
component video cord. If both cords are used,
pictures may not be played properly.
NOTE
• In order to enjoy pictures with Progressive mode
A
( page 27), the TV is required to have Progressive
video input.
• If the component video input jacks of your TV are
BNC type, use a plug adapter (not supplied) to
convert the plugs.

Connecting the power cord

Main unit
• Connect the power cord after all other
connections are complete.
• The STANDBY lamp (on the front panel) will be
lit.
Getting started
Component video cord
(sold separately)
Main unit
AC outlet
Supplied power cord
Connection
Main unit
12