Playing Discs; Playback - JVC EX-A1 Manual De Instrucciones

Playing discs

Playback

• The power will be turned on when any of
, or
, or
pressed while the power is off.
If any button other than
pressed, the source will also be changed (if
there is a disc loaded, playback will start).
NOW READING
REGION CODE
ERROR!
NO DISC
OPEN
CLOSE
13
(Refer to page 17 for playing MP3 and JPEG.)
A
2
Press 0 OPEN/CLOSE to open the disc
tray to load a disc.
3
Press 3 (play).
The disc tray will close and playback will start.
on the main unit and
on the remote control is
or is
Screens displayed on the TV when the power is turned ON.
The following messages appear depending on the status of the system.
(When FM/AM or AUX is selected as a source, the messages do not appear.)
Appears when the system is reading the disc information. Wait for a while.
Appears when the Region Code of the DVD does not match the code the
system supports. (A page 3)
Appears when no disc is loaded.
Appears when opening the disc tray.
Appears when closing the disc tray.
page 6
1
Press F AUDIO.
• The power will be turned on and the STANDBY
lamp will go off.
• Press F AUDIO again to turn off the power.
NOTE
,
• A menu screen may be displayed after starting
playback of a DVD. In this case, select a desired
,
item to playback by using the following buttons on
the remote control.
• Select a desired item using
press
• Select a desired item using the number buttons.
• Depending on the disc, actual operation may be
different from the description.
Place a disc with the label side
facing up.
•
Place an 8 cm disc in to the
hollow part in the cen
.
ter.
and