Publicidad
Idiomas disponibles
Idiomas disponibles
RECORDING
Zoom indicator
Downloaded from:
https://www.usersmanualguide.com/
Basic Features
Zoom-in
T
T
T
W
W
W
Zoom-out
RETAKE
Power zoom switch
START/STOP
VISS
RM-V20U (optional)
FEATURE:
Zooming
PURPOSE:
Varies the focal length of the lens and
produces the zoom in/out effect.
OPERATION:
Zoom In
T
1) Pull the power zoom switch down
W
Zoom Out
2) Push the switch up toward "W".
NOTES:
● The further the power zoom switch is
pushed, the faster the zoom speed
becomes.
● Focusing may become unstable during
zooming. In this case, set the zoom while
in Record–Standby, set manual focus or
Focus Lock (
or out in Record mode.
FEATURE:
Quick Review
PURPOSE:
To check the end of the last recording.
OPERATION:
1) Press "
NOTE:
Distortion may occur at start of playback.
This is normal.
FEATURE:
Retake
PURPOSE:
To re-record certain segments.
OPERATION:
1) Make sure the camcorder is in the
2) Press either RETAKE button to reach the
3) Press Recording Start/Stop to start
NOTE:
Noise may appear during Retake.
This is normal.
FEATURE:
Index Code Marking
PURPOSE:
To give you automatic access to any selected
point on a recording. Auto Marking and
Manual Marking are available.
OPERATION:
Auto Marking
An index code is always marked to start the
first recording on a new date after a cassette
is inserted.
Manual Marking (Using the optional
RM-V20U Remote Control Unit)
1) Press VISS once to place the index code.
NOTES:
● If VISS is pressed during
Record–Standby mode, the mark is
placed where START/STOP is pressed.
● If the date changes during a recording, it
becomes the first recording of the new
date and an index mark is placed at that
point.
15
toward "T".
pg. 20, 21), then zoom in
" for less than 2 seconds during
the Record–Standby mode.
• Tape is rewound for about 2 seconds
and played back automatically, then
pauses in Record–Standby mode for the
next shot.
Record–Standby mode.
start point for new recording.
recording.
INDEX blinks in the viewfinder during
marking.
Publicidad
