Publicidad
Idiomas disponibles
Idiomas disponibles
16
NOTES:
● A cassette holder can't be opened unless a power supply is attached.
● There may be a delay after you slide EJECT until the holder opens. Do not use force.
● The tape's remaining time is displayed in the viewfinder as shown.
● The indicated remaining time is approximate.
● The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary
● The tape remaining time displayed in the viewfinder is correct only if the correct tape length has been
● "TAPE END" appears when the tape reaches its end, and the power goes off automatically if left in this
● If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations,
● If you're recording on a cassette from the middle, use the RETAKE function (
● The LENS COVER warning blinks for about 8 seconds when the camcorder is turned on, when the cover is
Downloaded from:
https://www.usersmanualguide.com/
EN
LENS COVER
SWITCH
POWER
Start/Stop
The power indicator
25min
Tally lamp
Tape remaining time indicator
120min
119min
3min
2min (Blinking)
1min (Blinking)
0min (Blinking)
*
min.....(Now calculating)
according to the type of tape used.
selected (
pg. 12).
condition for 5 minutes. "TAPE END" also appears when a cassette whose tape is already at its end is
loaded.
the camcorder's power shuts off automatically. Set the Power switch to "POWER OFF", and then back to
"CAMERA" to turn the camcorder on again.
the last recording so you don't erase any of it.
closed.
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power (
pg. 8)
● Tape Length (
pg. 12)
● Recording Mode Setting (
pg. 13)
● Grip Adjustment (
pg. 14)
LOAD A CASSETTE
1
Slide EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
ENTER RECORD–STANDBY MODE
2
Slide the LENS COVER open/close switch to open
the lens cover, then set the power switch to
"CAMERA".
•The power indicator lights and the camcorder
enters the Record–Standby Mode.
•The scene you're aimed at appears on the
viewfinder screen, with the word "PAUSE"
superimposed upon it.
START SHOOTING
3
Press the RECORDING START/STOP button.
•The tally lamp lights while recording is in progress,
REC
and "
" appears in the viewfinder.
•If you want to turn the tally lamp off, see page 31.
STOP RECORDING
4
Press the RECORDING START/STOP button again to
stop recording.
•The camcorder re-enters the Record-Standby
mode.
pg. 18) to find the end of
Basic Recording
Publicidad
