Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
INSTALLING THE INPUT
CARD
Optional input cards are necessary to use the functions of this
monitor. Before mounting the monitor or connecting other
equipment to the monitor, be sure to install the input cards.
1. Turn off the Multi-Format Monitor's main
power and unplug the power cable from
the AC outlet.
2. Unscrew the screws and remove the slot
cover from the slot (on the rear side of the
monitor) in which you are going to install
the card.
3. Insert the Input Card's board (green-
coloured) into the slot, fitting the board
into the guide rails on the top and bottom
of the slot.
Fit the board to
the guide rails.
Knob
Input card (the illustration
shown is of the IF-C01PNG)
Knob
4. Push the Input Card in so that its front
panel touches the monitor's rear panel.
5. Secure the Input Card by replacing the
screws removed in Procedure 2.
NOTES:
• Do not touch the terminal connected to the monitor or board
pattern.
• Do not remove slot covers from the monitor's slots if they
are not in use.
REMOTE
MAKE/TRIGGER
RS-485
IN
OUT
Slot cover
Rear side of the DT-V1910CG
Multi-Format Monitor
REMOTE
MAKE/TRIGGER
RS-485
IN
OUT
Guide rails
REMOTE
MAKE/TRIGGER
RS-485
IN
OUT
ATTACHING THE WIDE
MASK
A wide mask is provided with the monitor. This changes the
viewable screen area to the 16:9 aspect ratio.
•
The wide mask cannot be attached to the monitor after the
monitor is mounted in a rack. Mount the wide mask before
installing the monitor in a rack.
1. Prepare the provided wide mask and 4
screws (for attaching).
2. Attach the wide mask to the monitor.
3. Secure the wide mask with the screws (fix
2 screws each to both right and left side).
● When detaching the wide mask, follow this procedure in
reverse.
Caution:
Use only the provided screws.
11
Publicidad
