Denver TVD-1438 MPEG 4 Manual Del Usuario página 3

SAFETY PRECAUTIONS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER(OR BACK).
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
The graphic symbols on the back cover of the set mean the following:
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert
the user to the presence of uninsulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying the appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
INSTALLATION
LOCATE the receiver in the room where direct light does not strike the screen. Total darkness or a reflection on
the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.
ALLOW enough space between the receiver and the wall to permit proper ventilation.
AVOID excessive warm locations to prevent possible damage to the cabinet or component failure.
CONNECTION
This TV receiver can be connected to 200V-240V ~ 50Hz, NEVER connect to DC supply or any other power.
AUTOMATIC DEGAUSSING
All colour television receivers are sensitive to magnetic influences, usually caused by either moving the receiver
from one place to another or using certain electrical appliances near the receiver. This residual magnetism as it
is called, sometimes causes distortion which gives rise to "blotchy" areas of colour in the picture. To avoid these
effects the receiver incorporates an automatic degaussing circuit which operates for a short while immediately
each time the receiver is switched on using the mains switch. This circuit removes any residual magnetism in
the metal parts of the picture tube and therefore ensures that each time the receiver is switched "ON" using the
Mains switch, the purity of the colours displayed on the screen remain true and lifelike. If the set is moved or
faced in a different direction, the mains switch must be switched off at least 10 minutes in order that the
automatic degaussing circuit operates properly.
EN 2