Denver TVD-1438 MPEG 4 Manual Del Usuario página 7

NOTE:
1. If The Remote Controller Will Not Be Used For A Long Period Of Time Or If The Batteries Run Out,
Please Take Out The Batteries To Prevent Leakage.
2. Do not drop the batteries into fire.
3. Make sure not to drop, dampen, disassemble the remote.
INITIAL OPERATION
CONTROL YOUR TV
HOW TO POWER ON/OFF THE RECEIVER
1. Press the main power switch on the set board. The indicator will turn on.
2. If no picture shows on screen, it indicates the set in standby. There after press "
controller.
NOTE:
Besides the " " button, pressing the direct select button (0~9) is effective to activate the receiver. If any
preferred channel has been preset, selecting the corresponding number button (0~9) can direct to the
target program.
If the remote controller is not currently available, the receiver can also power on by the press of
"CH+,CH-" on the set board.
NOTE:
This only works when the set is receiving TV Signal.
3. Press the " " button on the remote controller to switch the receiver to standby mode.
4. Press the main switch to power off the receiver. The power indicator will turn off.
NOTE:
1. If the power is cut-off electrically when appreciating programs, the receiver shall be turned off
completely or disconnect the power plug;
2. Turn off the receiver completely if long period of non-use for the power consumption is about 10W in
standby mode.
TV PLAYER OPERATION
Operations by the keys on the Front Cabinet
1 Main Power Switch
Press to switch on the main power. The set will go into power on or standby mode and the
indicator will be alight . When it is pressed again,TV set can be turned off.
2 Program Selector CH+ and CH- buttons
Under standby mode, press CH
TV channel or CH- to select downwards the TV channel, program number will be displayed for 4 sec.
3 Volume V+ and V- buttons
Press V
will be displayed.
4 MENU and OK button
To minimize the number of keys on remote , the less frequent used
+
+
to increase the sound level or V
or CH - to turn the set on. Press CH
-
to decrease the sound level, volume bar
EN 6
" button on the remote
+
to select upwards the