Emerson RAH ECO Manual página 11

4. How to Hang Your Ceiling Fan
4.4
Rotate the Retaining Strap closed (Figure 15) on the
Hanger Bracket.
Reinstall the Socket Head Cap Screw (previously
removed). Securely tighten the Socket Head Cap Screw
(Figure 15).
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
5.1
Connect the Green Grounding Lead from the Hanger Ball
and the Green Grounding Lead from the Hanger Bracket
to the Grounding Conductor of Supply (this may be a bare
wire or wire with green colored insulation).
Securely connect wires with Wire Connectors (supplied)
(Figure 16).
5. How to Wire Your Ceiling Fan
Figure 15
GROUND
CONDUCTOR SUPPLY
LISTED WIRE
CONNECTOR
GREEN WIRE
(GROUND) FROM
HANGER BALL
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
Figure 16
!
This product is designed to use only those parts supplied
with this product and/or any accessories designated
specifically for use with this product by Emerson Electric
Co. Substitution of parts or accessories not designated
for use with this product by Emerson Electric Co. could
result in personal injury or property damage.
11
(Continued)
RETAINING STRAP
HANGER BRACKET
SOCKET CAP SCREW
HEX WRENCH
WARNING
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF915