Emerson RAH ECO Manual página 9

WARNING
!
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 11).
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
WARNING
!
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as "Acceptable for Fan Support of
22.7 kg. (50 lbs.) or less".
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7 kg. (50 lbs.) or less", and use screws
supplied with outlet box. Most outlet boxes commonly
used for support of light fixtures are not acceptable for
fan support and may need to be replaced. Consult a
qualified electrician if in doubt.
4.1
Securely attach the Hanger Bracket to the Outlet Box
using the two Screws supplied with the Outlet Box.
(Figure 12).
NOTE: Use only the Hanger Bracket supplied with this
Ceiling Fan.
WARNING
!
Hanger bracket must seat firmly against outlet box.
If the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are not
securely attached, the fan could wobble or fall.
4. How to Hang Your Ceiling Fan
AT
LEAST
7'
Figure 11
Figure 12
9
CEILING
FLOOR
OUTLET
BOX
HANGER
BRACKET
OUTLET BOX
SCREWS (2)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF915