Emerson RAH ECO Manual página 17

6.8
Tuck the Wires and Terminals into the LED Light Fixture
Assembly and position on the Lower Housing.
NOTE: Make sure Wires and Terminals are positioned
under the LED Light Fixture Assembly and not
pinched between LED Light Fixture Assembly and
Lower Housing.
Rotate the LED Light Fixture Assembly counter-clockwise
to engage the key hole slots onto the two #8-32 x 3/8" Pan
Head Screws (Figure 28).
Secure the LED Light Fixture Assembly by tightening the
two #8-32 x 3/8" Pan Head Screws.
Reinstall and tighten the previously removed #8-32 x 3/8"
Pan Head Screw.
A spare #8-32 x 3/8" Pan Head Screw is supplied in the
loose parts bag, if required.
WARNING
!
To avoid possible fire or shock, make sure that the electrical
wires and connectors are completely inside the lower
housing and not pinched between the LED light fixture
assembly and lower housing.
6.9
Place the Shade into the Lower Housing, aligning the
three flat areas on the top flange of the Shade with the
three raised Dimples on the inside of the Lower Housing
(Figure 29).
Then turn the Shade clockwise until it stops turning.
NOTE: Periodically check that the Shade is seated
fully clockwise in the Lower Housing.
Please call Emerson
1-800-654-3545 if you
about installation and operation of this ceiling fan.
6. Final Installation
technical support
have any questions
(Continued)
TIGHTEN #8-32 x 3/8"
PAN HEAD SCREWS
LED LIGHT FIXTURE
ASSEMBLY
Figure 28
at
FLAT AREA
OF SHADE
SHADE
Figure 29
17
REINSTALL ONE #8-32 x 3/8"
PAN HEAD SCREW
LOWER HOUSING
RAISED DIMPLES (3)
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF915
emersonfans.com