Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Make sure the on/stop switch is in the
STOP "
" position and the chain has stopped
before performing any maintenance on the saw.
Failure to do so may result in serious personal
injuries.
WARNING:
Muffler surfaces are very hot during and after
operation of the chain saw; keep all body parts
away from the muffler. Serious burns could
occur if contact is made with the muffler.
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a
hazard or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing and head protection. Failure to do so
could result in objects being thrown into your
eyes and other possible serious injuries.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove
dirt, dust, lubricant, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils,
etc., come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic
which may result in serious personal injury.
MAINTENANCE
LUBRICATION
All of the bearings in this product are lubricated with
a sufficient amount of high grade lubricant for the
life of the unit under normal operating conditions.
Therefore, no further lubrication is required.
Page 25 — English
BAR MOUNTING
NUTS
CLUTCH
COVER
BAR MOUNTING
RUN
POSITION
Fig. 34
COMBINATION
WRENCH
Fig. 35
NUTS
Fig. 36
Publicidad
