Power Stroke PS803155E Manual Del Operador página 11

WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
TOOLS NEEDED
See Figure 2.
The following tools (not included or drawn to scale) are
needed for assembly:
 Phillips Screwdriver
INSTALLING THE HANDLE
See Figure 3.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Push and hold the push-pin button on the side of the handle
as you slide the handle onto the frame.
NOTE: Before use, pull the handle up until the push-pin button
snaps through the locking slots to secure the handle in place.
INSTALLING THE TRIGGER HANDLE
HOLDER
See Figure 4.
 Insert the nut into the trigger handle holder.
 Align the trigger handle holder with the holes in the handle
and panel, as shown.
 Insert the screw through the hole.
 Install nuts and tighten securely with a Phillips screw-
driver.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 5.
 Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
 Turn the connector until it stops to secure the spray wand
in place.
ASSEMBLY
CONNECTING THE BATTERY
See Figure 6.
WARNING:
To reduce the risk of electric shock or explosion, do not
short circuit the battery terminals or charge in a sealed
container. Keep sparks and flame away. Do not use
metal tools for connections and keep metal objects away
from the battery terminals. Metal objects can make a
connection from one terminal to another. Shorting the
battery terminals together can cause sparks, burns, or
a fire.
The starter cable on the pressure washer must be connected
to the connection port on the battery and the battery must be
fully charged before the electric start feature of the pressure
washer can be operated.
To connect the battery:
 Remove the cap from the connection port on the battery.
 Connect the starter cable on the pressure washer to the
connection port on the battery, making sure the plug is
fully seated.
CONNECTING THE HIGH PRESSURE HOSE
TO THE TRIGGER HANDLE
See Figure 7.
 Screw the collar on the non-sleeved end of the high pres-
sure hose into the trigger handle inlet coupler by turning
the hose collar clockwise. Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 8.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
for more information about using the high pressure hose.
 Align the collar on the sleeved end of the hose to the
threaded outlet on the pump.
 Install the high pressure hose collar onto the threaded
outlet.
 Turn the collar clockwise to tighten the hose securely to
the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.
Page 7 — English