Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the door and the glass panel
WHAT TO DO IF...
Warning! Refer to "Safety information"
chapter.
90°
2
1
5. Release the locking system to remove
the internal glass panel.
6. Turn the two fasteners by 90° and re-
move them from their seats.
7. Carefully lift (step 1) and remove (step
2) the glass panel.
8. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the in-
ner side of the door. Make sure that after
the installation the surface of the glass pan-
el frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the internal glass
panel in the seats correctly. Refer to the il-
lustration.
progress 13
Publicidad
