Stihl FSA 90 R Manual De Instrucciones página 13

DANGER
Do not rely on the tool's
insulation against elec-
tric shock. To reduce the
risk of electrocution,
never operate this power
tool in the vicinity of any
wires or cables (power,
etc.) which may be carry-
ing electric current.
The power tool may be used in rain and
wetness. Dry the power tool after
finishing work.
Do not leave the machine outdoors in
the rain.
Be particularly alert and cautious when
wearing hearing protection because
your ability to hear warnings (shouts,
alarms, etc.) is restricted.
USING THE CUTTING ATTACHMENT
For instructions on proper mounting see
the chapter on "Mounting the Cutting
Attachment" in your instruction manual.
Mowing heads are to be used only on
trimmers equipped with a line-limiting
blade in the deflector in order to keep the
line at the proper length (see "Main
Parts" chapter in your instruction
manual.)
Do not use with mowing line longer than
the intended length. With a properly
mounted deflector, the built-in line-
limiting blade will automatically adjust
the line to its proper length.
Using the unit with an overly long nylon
cutting line increases the load on the
motor and reduces its operating speed.
FSA 90 R
This results in overheating and damage
to important components (e.g. polymer
housing components.)
WARNING
To reduce the risk of serious injury,
never use wire or metal-reinforced line
or other material in place of the nylon
cutting lines. Pieces of wire could break
off and be thrown at high speed toward
the operator or bystanders.
STIHL AutoCut mowing head
Nylon cutting cord advances
automatically when tapped against the
ground (TapAction).
After Finishing Work
Always clean dust and dirt off the power
tool – do not use any grease solvents for
this purpose.
MAINTENANCE, REPAIR AND
STORING
If you make a warranty claim for a
component which has not been serviced
or maintained properly or if
nonapproved replacement parts were
used, STIHL may deny coverage.
WARNING
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Strictly follow the maintenance and
repair instructions in the appropriate
section of your instruction manual.
Please also refer to the maintenance
chart in this manual.
Always switch off the
motor, move retaining
latch to ƒ, remove the
battery from the power
tool and make sure that
the cutting attachment is
stopped before doing any
maintenance or repair
work, such as replacing
the cutting attachment, or
cleaning the power tool.
This avoids the risk of the
motor starting
unintentionally.
WARNING
Do not attempt any maintenance or
repair work not described in your
instruction manual. Have such work
performed by your STIHL servicing
dealer only.
WARNING
Never repair damaged or broken heads.
This may cause parts of the cutting
attachment to come off and result in
serious or fatal injuries.
Tighten all nuts, bolts and screws after
each use.
Regularly check the electrical contacts
and ensure that the insulation of the
power cord and plug of the charger is in
good condition and shows no sign of
aging.
Electrical components, e.g. power cord
of charger, may only be repaired or
replaced by a qualified electrician.
Clean plastic components with a cloth.
Do not use aggressive detergents. They
may damage the plastic.
English
11