Stihl FSA 90 R Manual De Instrucciones página 9

Use only for charging geometrically
matching STIHL batteries with a
maximum rated capacity of 50 Ah and a
maximum voltage of 42 V.
WARNING
Never charge defective, damaged,
cracked, deformed or leaking batteries.
To reduce the risk of shock and/or fire,
connect the charger only to a power
supply with the voltage and frequency
specified on the rating plate. Always
plug the charger into a properly installed
wall outlet. Do not use an extension cord
unless absolutely neccessary (see
below).
Protect the charger from
rain and dampness. Keep
charger dry.
WARNING
Never insert a wet battery into the
charger. Such a battery could cause the
charger to short circuit.
Use and store charger
only indoors in dry rooms.
Operate charger at temperatures
between 41 °F (5 °C) and 104 °F
(40 °C).
Allow the charger to cool down normally
– do not cover it.
FSA 90 R
Never bridge the contacts of the charger
with metallic objects (e.g. nails, coins,
jewelry) – short circuit. The charger will
be damaged by a short circuit.
In the event of smoke or fire in the
charger, disconnect it from outlet
immediately.
WARNING
To reduce the risk of electric shock or
short circuit, do not insert any objects
into the charger's cooling slots.
WARNING
The charger heats up during the
charging process. Do not operate on an
easily combustible surface (e.g. paper,
cardboard, textiles) or in an easily
combustible environment – risk of fire.
WARNING
Do not operate in a hazardous location,
i.e. in a location where there are
combustible liquids (fumes), vapors or
dusts. Chargers can produce sparks,
which may ignite the dust or vapors –
risk of explosion.
Never use a charger with damaged
housing. Do not operate the charger if it
has received a sharp blow, been
dropped or otherwise damaged in any
way.
Check the charger's
power supply cord and
plug regularly for dam-
age. If the power supply
cord or plug is damaged,
immediately disconnect
the plug from the wall
outlet to avoid the risk of
electric shock.
Never jerk the power supply cord to
disconnect it from the wall outlet. To
unplug, grasp the plug, not the cord.
Have a damaged power supply cord
repaired by an experienced electrician.
Do not use the power supply cord for
any other purpose, e.g. for carrying or
hanging up the charger.
Never use power supply cords that do
not comply with regulations.
Make sure the power supply cord is
located and/or marked so that it will not
be stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise be subjected to
damage or stress.
WARNING
To reduce the risk of shock and/or
overheating and fire, an extension cord
should not be used unless absolutely
necessary. If an extension cord must be
used, plug the charger into a properly
wired 16 gauge (AWG 16) or heavier
gauge extension cord with blades that
are the same number, size and shapes
as the blades on the charger.
English
7