Publicidad
Idiomas disponibles
Idiomas disponibles
en
Cleaning the burner heads
To avoid possible burns, do not attempt cleaning
before turning off all surface burners and allowing
them to cool.
Any additions, changes, or conversions required in
order for this appliance to satisfactorily meet the
application needs must be made by an authorized
qualified Agency. Routinely clean the cooktop. Wipe
with a clean, damp cloth and wipe dry to avoid
scratches. Keeping the surface burner head ports
and slots clean will prevent improper ignition and an
uneven flame.
To clean recessed and contoured areas of cooktop:
•
If a spill occurs on or in the recessed or con-
toured areas, blot up spill with an absorbent
cloth.
•
Rinse with a clean, damp cloth and wipe dry.
CAUTION
To avoid possible burns do not attempt to operate
the surface burners without the burner caps.
Do not use spray oven cleaner on the cooktop.
To clean burner heads:
1. Remove the burner cap and burner head (see
Figure 11). Clean the cap and head with hot
soapy water and dry thoroughly.
2. For burned-on and dried spills, apply hot soapy
water to the burner cap and head to allow time
for the soils to soften.
3. Use a toothbrush to clean all over the burner
head.
4. Wipe the burner cap and head clean with a soft,
clean cloth, sponge, or scratch-free cleaning
pad. Wipe out burner orifice with a cloth before
placing burner head and cap back on. The burn-
er assembly must be completely dry before use.
5. Make sure the burner caps and heads are placed
and seated properly over the ignitor. The three
mounting legs on burner will align with slots on
the orifice holder. When placed correctly, the
burner cap should not move off the burner head
(see "Assembly of the Burner Caps" on page 9).
6. If burner fails to light, recheck placement of
burner head to the orifice holder and cap.
CARE AND CLEANING
Burner Cap
Burner Head
Orifice Holder
Ignitor
Figure 11: Removeable burner components
Important notes:
•
Always keep the surface burner caps in place
whenever a surface burner is in use.
•
When replacing the burner caps, be sure the
burner caps are seated firmly on top of the
burner heads.
•
For proper flow of gas and ignition of burners
do not allow spills, food, cleaning agents, or
any other material to enter the gas orifice port
opening.
17
Publicidad
