Publicidad
Idiomas disponibles
Idiomas disponibles
English
● When the pilot lamp fl ikers rapidly in red
(at 0.2-second intervals), check for and take out any
foreign objects in the charger's battery installation
hole. If there are no foreign objects, it is probable
that the battery or charger is malfunctioning. Take it
to your authorized Service Center.
BEFORE OPERATION
Read section titled "SAFETY" (pages 3–10).
Make sure of the followings before operation.
PREPARING THE BATTERY
Read section titled "SAFETY, IMPORTANT SAFETY
INSTRUCTIONS FOR BATTERY CHARGER" (page 7).
You must charge the battery before use.
The charging method of battery is shown in page 14–16.
HOW TO OPERATE SWITCH PANEL
Battery indicator
Battery indicator
switch
Switch panel
(1) Check Remaining battery level
When pressing the battery indicator switch, the
battery indicator shows Remaining battery level by
status of LED lamp as below.
Status of indicator
NOTE
● Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
● To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.ON.
16
Battery Remaining Power
The battery remaining
power is enough.
The battery remaining
power is about half.
The battery remaining
power is nearly empty.
Recharge the battery as
soon as possible.
(2) How to use the LED light
Every time you press the light switch on the switch
panel, the LED light lights or goes off .
To prevent the battery power consumption, turn off
the LED light frequently.
Light switch
Switch panel
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 5 minutes.
(3) LED light warning signals
This product features functions that are designed to
protect the tool itself as well as the battery.
While the switch is pulled, if any of the safeguard
functions activate during operation, the LED light will
blink as described in Table.
When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and
follow the instructions described under corrective action.
Publicidad
