Publicidad
Idiomas disponibles
Idiomas disponibles
Status
Overload State
High Temperature State
(4) Remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to
light the indicator lamp. (Table 5)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is
pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
State of lamp
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Remaining battery
indicator switch
Table 5
Battery Remaining Power
Remove the battery and clean the area
around the blade guide and drive blade
according to the instructions on page 24
"MAINTENANCE AND INSPECTION".
Allow the tool to fully cool down.
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow
it to fully cool down.
Blinks ;
Output suspended due to
failure or malfunction. The
problem may be the battery so
please contact your dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
TESTING THE NAILER
● Operators
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
● Never place your face, hands or feet near
fi ring head when using.
CAUTION
● Use caution not to throw the push lever tip onto
wood.
Before actually beginning the nailing work, test the Nailer
by using the checklist below. Conduct the tests in the
following order.
English
Corrective Action
DANGER
and
others
WARNING
in
17
Publicidad
