Publicidad
Idiomas disponibles
Idiomas disponibles
Magazine
Nail
Bottom of groove
(4) Push the nails in the magazine into the blade guide
with your fi ngers.
(5) Push the magazine cover forward to return it to the
closed position, checking that the nails do not stick
out above the uneven surface of the magazine.
NOTE
● Close the magazine cover gently.
Applying excessive force may result in deformation
of the nail strip, preventing the magazine cover from
closing.
● If the magazine cover is hard to close, check the
groove of the magazine.
Nails sometimes get into the groove. If this happens,
tilt the power tool and remove the nails with a
precision screwdriver or thin bar. In particular, if any
nails get into the hole shown in the cross-section
drawing, remove them through the window in the
back of the magazine.
Each groove of the magazine
The Nailer is now ready to operate.
Removing the nails:
(1) Press the stop lever and pull out the magazine cover.
(2) Remove the nails from the blade guide or magazine.
Magazine Cover
Gap
Blade Guide
NOTE
● If the strip breaks inside the blade guide, nails may be
left behind when the nails at the front are removed.
● Check carefully inside the blade guide, as it will be
hard to see any nails that have been left behind there.
● If nails get jammed and cannot be removed, refer to
the section "CLEARING A JAM."
NAILER OPERATION
Read section titled "SAFETY" (pages 3–10).
● Do not use the electrical cord if damaged.
Have it repaired immediately.
● Choice of triggering method is important.
Please read and understand "METHODS OF
OPERATION" found below.
● Never place your face, hands or feet near
fi ring head when using.
Stop Lever
Push
Pull out
Pull out the nail
DANGER
● Operators
and
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
WARNING
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from
trigger when not driving nails
to avoid accidental fi ring.
English
Nail
others
in
19
Publicidad
