Grundfos NK Serie Instrucciones De Instalación Y Funcionamiento página 23

Aligning the pump and motor with laser equipment
Step
1
2
3
4
5
6
Action
Make a rough alignment
of pump and motor, and
tighten the screws with
correct torque in the
base frame. See the
table "Tightening
torques".
Fasten one laser bracket
on the pump coupling.
Fasten the other laser
bracket on the motor
coupling.
Laser unit S (Stationary)
is on the stationary part.
Laser unit M (Movable)
is on the part that is
moved.
Interconnect the laser
units, and connect one
laser unit with the control
box.
Make sure that the laser
units are at the same
height.
Step
7
8
9
10
11
12
Action
Measure the distance
between the white lines
on the laser units.
Enter the distance.
Measure the distance
between the S unit and
the centre between the
couplings.
Enter the distance.
Measure the distance
from the S unit to the
first screw on the motor.
Enter the distance.
23