Manual Flash Exposure Correction - Metz mecablitz 64 AF-1 digital Manual De Instrucciones

8 Manual flash exposure
The auto flash exposure mode of most came-
ras is adjusted to a reflection factor of 25%
(the average reflection factor of flash sub-
jects).
A dark background that absorbs much of the
light or a highly reflective bright background
(backlit shots, for example) may result in,
respectively, underexposure or overexposure
of the subject.
To offset these effects, the flash exposure
can be adjusted manually for the shot with a
correction value. The extent of the correction
depends on the contrast between the subject
and background!
In
correction factors of from -3 EV (f-stops) to +3
EV (f-stops) can be adjusted on the flash unit
k
in one-third increments.
Tip:
Dark subject against light background: posi-
tive correction factor.
Light subject against dark background:
negative correction factor.
Exposure correction by means of alteration of
the lens aperture setting is impossible, since
the camera's automatic exposure program
regards the altered aperture setting as the
normal working aperture setting.
When setting the correction factor, the
distance shown in the display can change
178
correction
A/TTL flash modes, manual flash exposure
and be adjusted to the correction factor
(depending on the camera model)!
TTL
Setting procedure
• Press the
0.8 - 9.0 m
display as many times as it takes for the
M-
partial light output selection to appear.
m
35
Zoom
m
EV
O
• Press the
EV
touch display and set a correction value.
-1 1/3
-1
• Press the selected correction value on the
-2/3
touch display, e.g.
p The setting will take effect immediately.
q
Manual flash exposure correction is only pos-
sible in TTL flash mode if the camera sup-
TTL
ports this function (consult the camera's ope-
rating instructions)!
1.1- 12 m
M-
m
35
Zoom
m
If the camera does not support this function,
EV
the adjusted correction will have no effect.
-1
For some camera models, the manual flash
exposure corrections must be adjusted on
the camera. If this is the case, no correction
value will appear on the flash unit display.
+
After the shot, remember to cancel the manu-
al flash exposure correction in the camera!
EV
sensor buttons on the touch
sensor buttons on the
-1
.