Scheppach Compact 10t Traduccion Del Manual De Instrucciones Originale página 38

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
we wish you much pleasure and success in working
with your new device.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE 0113 not being observed.
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
38 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1 - 16)
1. Splitting column
2. Chain hook
3. Chain
4. Riving knife
5. Transport handle
6. Control arms
6a. Support points
7. Transport lever
8. Lever
9. Trunk lifter
10. Locking hooks
11. Transport wheels
12. Supports
13. Base plate
14. Swivel table
15. Hoop guard
15a. Holder
16. Control lever
17. Handle guard
18. Retaining claw
18a. Hole
19. Stop lever
20. Electrical power connection
21. Engine
22. On/off switch
23. Ventilation screw
24. Hydraulic oil tank
25. Oil drain screw
26. Retaining bolt
27. Rocker switch
28. Cotter pin
29. Stop screw
30. Oil dipstick
31. Cap nut (stroke setting bar)
32. Locking screw (stroke setting bar)
33. Stroke setting bar
www.scheppach.com