Scheppach Compact 10t Traduccion Del Manual De Instrucciones Originale página 52

17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor (21) is running,
splitting column (1) does
not move up.
The motor (21) ends
the splitting process
automatically.
The splitting column (1)
only moves down slowly.
Log is not split.
Splitting column (1)
vibrates,
generates noises.
Splitting column (1)
vibrates strongly in the
upper position.
Hydraulic pump whistles.
Oil leakage at splitting
column (1)
or in other places.
52 | GB
Possible cause
Motor (21) turns in the wrong direction.
Overvoltage protective device was
triggered.
Not enough oil available.
Screws on the control lever (16) are
loose.
Bleed screw (23) is closed.
Check if the cap nut (stroke setting bar)
(31) of the stroke setting bar (33) is loose.
Log splitter loaded incorrectly.
Splitting wedge (2) is blunt.
Oil leaks.
Low oil and excess air in the hydraulic
system.
Plastic guides are worn out.
Too little hydraulic oil in the hydraulic oil
tank (24).
Trapped air in the hydraulic system
during operation.
Bleed screw (23) not tightened before
transport.
Oil drain screw (25) loose.
Oil valve and/or seals defective.
www.scheppach.com
Remedy
Turn the phase inverter in the power
connection (see point 10.6).
Call a qualified electrician.
Check oil level with oil dipstick (30)
screwed in.
Tighten the screws on the control lever
(16).
Loosen the bleed screw (23) two turns
before use.
Tighten the cap nut (stroke setting bar)
(31) of the stroke setting bar (33). If
necessary, fit a new cap nut.
Insert the log correctly.
Grind the splitting wedge (2).
Locate the leak, contact the dealer.
Check the oil level, top up if necessary,
otherwise contact the dealer.
Replace the plastic guides at the top and
bottom.
Top up hydraulic oil.
Loosen the bleed screw (23) two turns
before use.
Tighten bleed screw (23) before
transport.
Tighten the oil drain screw (25) firmly.
Contact dealer.