Hitachi YUTAKI S Serie Manual De Instalación Y Funcionamiento página 19

TRANSPORTATION,
HANDLING AND UNITS
INSTALLATION
9. TRANSPORTATION, HANDLING AND UNITS INSTALLATION
9.1. TRANSPORTATION OF OUTDOOR UNIT
9.1.1. TRANSPORTATION
Transport the product as close to the installation location as practical before unpacking.

CAUTION:
Do not put any material on the product.
Apply two lifting wires onto the outdoor unit, when lifting it by crane.
9.1.2. HANDLING OF OUTDOOR UNIT

WARNING:
Do not put any foreign material into the outdoor unit and
check to ensure that none exists in the outdoor unit before
the installation and test run. Otherwise, a fire or failure,
etc. may occur.
■
Hanging Method
When hanging the unit, ensure a balance of the unit, check
safety and lift up smoothly.
1. Do not remove any packing materials.
2. Hang the unit under packing condition withtwo (2) ropes,
as shown in the figure.
Wire rope
Over 60º
0.7 to 1.0m
Do not remove the
plastic band or the
corrugate paper frame
Pass the wire ropes
through each lifting
hole in the wooden
base as shown

CAUTION:
- Lift the outdoor unit in its factory packaging with 2 wire
ropes.
- For safety reasons ensure that the outdoor unit is lifted
smoothly and does not lean.
- Do not attach lifting equipment to the plastic band or the
corrugated paper frame.
- Ensure the exterior of the unit is adequately protected
with cloth or paper.
■
When Using Handles
When manually lifting the unit using the handles, pay attention to
the following points.
1. Do not remove the wooden base from outdoor unit.
2. To prevent the unit from overturning, pay attention to
the center of gravity as shown in the below figure.
3. Two or more personnel should be used to move the
unit.
Center of gravity
410
Handle
Wooden base
PMML0215A rev.1 - 02/2012
o
Aprx.20
21