Stihl Multioil Bio; Symbols On The Garden Pruner, Battery And; Charger; Engineering Improvements - Stihl GTA 26 Manual De Instrucciones

English
WARNING
￭ A typical household electrical circuit is between 15 and
20 amps. A single STIHL AL 1 charger draws
approximately 0.275 amps. To reduce the risk of fire from
overloading an electrical circuit:
– Ensure the electrical system is rated to withstand the
expected electrical draw before charging your
battery.
– Charge multiple batteries one at a time or on
separate circuits, unless you know your circuit can
handle the total expected draw from multiple
chargers.

24.7 STIHL Multioil Bio

See product labeling for use, handling and storage
instructions. For further information regarding the
STIHL Multioil Bio, please go to
www.stihlusa.com/information/sds.

24.8 Symbols on the Garden Pruner, Battery and

Charger

Symbol Explanation
V Volt
Hz Hertz
A Ampere
Ah Ampere hour
W Watt
Wh Watt hour
Maximum guide bar length
Direction of saw chain rotation
Certification/listing mark of UL
Certification/listing mark of CSA
40
STIHL products must not be disposed of in the
household trash, but only in accordance with local,
state and federal laws and regulations and as
provided in this manual, @ 27.
Direct current
Number of cells and stored energy according to cell
manufacturer's specification. Usable energy will be
less.
The RBRC seal indicates that STIHL has prepaid for
battery recycling
Read the manual
Use and store charger only indoors in dry rooms

24.9 Engineering Improvements

STIHL's philosophy is to continually improve all of its
products. As a result, engineering changes and
improvements are made from time to time. Therefore, some
changes, modifications and improvements may not be
covered in this manual. If the operating characteristics or the
appearance of your machine differs from those described in
this manual, please contact your STIHL dealer or the STIHL
distributor for your area for assistance.

24.10 FCC 15 Compliance Statement

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
– this device may not cause harmful interference.
– this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
24 Specifications
0458-694-8621-A