Publicidad
Idiomas disponibles
Idiomas disponibles
10
MAINTENANCE
IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight.
Check regularly that the handles are firmly mounted.
IMPORTANT
Use only the replacement parts and accessories of
the initial manufacturer.
10.1
GENERAL INFORMATION
IMPORTANT
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Use correct clothing, protective gloves and safety
glasses.
10.2
CLEAN THE MACHINE
• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
English
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
10.3
3
1.
2.
3.
4.
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5.
11
REPLACE THE SPOOL
Push the tabs (2) on the sides of the trimmer
head at the same time.
Pull and remove the spool cover (1).
Remove the spool (3).
1
2
3
Replace with a new spool.
NOTE
Put the end of the cutting line through the eyelet
(4).
EN
Publicidad
