Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.
Tighten the screw.
8.4
ASSEMBLE THE SHAFT
1.
Loosen the screw on the coupler.
2.
Push in the release button (1) on the lower shaft.
3.
Align the release button with the positioning hole
(2) and slide the two shafts together.
1
4.
Turn the lower shaft until the button locks into the
positioning hole.
The release button must be fixed in the positioning
hole. Using the wrong hole could lead to personal
injury, or damage to the unit.
5.
Tighten the screw with the hex wrench.
2
NOTE
English
8.5
ATTACH THE AUXILIARY HANDLE
1.
Remove the knob (1) from the handle.
2.
Attach the auxiliary handle and lower clamp (2)
on the shaft.
3.
Set the auxiliary handle in the comfortable
position.
4.
Put the bolt (3) through the holes.
5.
Tighten the auxiliary handle with the knob.
2
9
OPERATION
Before you operate the machine, read and
understand the safety regulations and the operation
instructions.
Be careful when you operate the machine and
always observe your surroundings before operating
tool.
8
3
1
IMPORTANT
WARNING
Publicidad
