Publicidad
Idiomas disponibles
Idiomas disponibles
Home Connect setup
Notes
Observe the Home Connect
■
supplementary sheet, which is
available for download under http://
www.siemens-home.bsh-group.com
with the instructions. To do so, enter
the E-number of your appliance in the
search field.
After switching on the appliance, wait
■
at least two minutes until internal
device initialisation is complete. Only
then start setting up Home Connect.
To make settings with Home Connect,
■
the Home Connect app must be
installed on your mobile device.
Please observe the Home
Connect documents supplied for
doing this.Follow the steps specified
by the app to make the settings.
If the appliance is not operated for a
■
long time, the Home Connect menu
closes automatically. You can find
information on how to open the Home
Connect menu at the start of the
appropriate sections.
Automatic connection with the home
network (WLAN)
If a WLAN router with WPS function is
available, you can automatically connect
the refrigerator to the home network.
1. Press the super button and the
lock button simultaneously to open the
Home Connect menu.
The display shows Cn.
Note
Press both buttons at exactly the
same time.Button operation is locked
if only the lock button is pressed for a
longer period. Press the lock button
again until the lock is deactivated.
2. Press the °C button repeatedly until
the displays AC and oF are shown.
3. Press the + button.
The appliance is ready for automatic
connection.
The display shows an animation for
2 minutes.
Follow the steps below during this
period.
4. Activate the WPS function on the
home network router (e.g. using the
WPS/WLAN button; information on this
topic can be found in the router
documentation).
If the connection is successful, on
■
flashes in the refrigerator display.
You can now connect the
refrigerator with the app.
If the display shows oF, it was not
■
possible to establish a connection.
Check whether the refrigerator is
located within the range of the
home network (WLAN).
Repeat the process or establish the
connection manually.
Manual connection with the home
network (WLAN)
If the WLAN router present does not
have a WPS function, or if this is
unknown, you can manually connect the
refrigerator with the home network.
1. Press the super button and the
lock button simultaneously to open the
Home Connect menu.
The display shows Cn.
Note
Press both buttons at exactly the
same time.Button operation is locked
if only the lock button is pressed for a
longer period. Press the lock button
again until the lock is deactivated.
2. Press the °C button repeatedly until
the displays SA and oF are shown.
en
15
Publicidad
