Publicidad
Idiomas disponibles
Idiomas disponibles
Preventing noises
The appliance is not level
Please align the appliance with a spirit
level. Use the height-adjustable feet
or place packing underneath them.
The appliance is not free-standing
Please move the appliance away
from adjacent units or appliances.
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
The light does not function.
Displays do not illuminate.
It is too cold in the cooling
compartment or the
hyperFresh compartment.
Possible cause
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Containers or storage areas wobble
or stick
Please check the removable parts
and re-insert them correctly if required.
Bottles or receptacles are touching
each other
Move the bottles or receptacles slightly
away from each other.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
Connect mains plug. Check whether the power
is on, check the fuses.
Increase the temperature in the cooling
compartment.
Increase the temperature in the hyperFresh
compartment.
en
27
Publicidad
