Setting The Assistance Level; Interaction Between The Ebike System And Gear-Shifting - Bosch Intuvia Instrucciones De Servicio

English – 10
OFF
If an eBike has two batteries inserted
MPH
into it and both batteries are
KM/H
charged on the bike, the charging
progress of both batteries will be in-
dicated on the display (the left-hand
battery is being charged in the illus-
tration). You can also tell by the
flashing indicator on the battery
which of the two batteries is being
charged at the moment.

Setting the assistance level

On the operating unit (9), you can set the level of as-
sistance you want the eBike drive to provide you with
while pedaling. The assistance level can be changed
at any time, even while cycling.
Note: In some models, the assistance level may be
preset and cannot be changed. There may also be
fewer assistance levels available than stated here.
The following assistance levels are available as a max-
imum:
– OFF: Motor assistance is switched off. The eBike
can just be moved by pedaling, as with a normal bi-
cycle. The push assistance cannot be activated at
this assistance level.
– ECO: Effective assistance with maximum effi-
ciency, for maximum range
– TOUR: Steady assistance, long range for touring
– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking
and for cycling in urban traffic
eMTB: Optimum assistance whatever the terrain,
rapid acceleration when starting from a standstill,
improved dynamics, top performance (eMTB is
only available in combination with drive units
BDU250P CX, BDU365, BDU450 CX and
BDU480 CX. This also requires a software update.)
– TURBO: Maximum assistance even at high pedaling
speeds, for biking sports
1 270 U20 XBI | (07.04.2020)
(13)
(12)
To increase the assistance level, press the + but-
ton (12) on the operating unit repeatedly until the re-
quired assistance level appears on the indicator (b).
To decrease the assistance level, press the – but-
ton (11).
The requested motor output is shown on the display
(a). The maximum motor output depends on the se-
lected assistance level.
When the on-board computer is removed from the
holder (4), the last indicated assistance level is
stored; the motor-output indicator (a) remains
empty.
Interaction between the eBike system and
gear-shifting
The gear-shifting should be used with an eBike drive
in the same way as with a normal bicycle (observe the
operating instructions of your eBike on this point).
Irrespective of the type of gear-shifting, it is advisable
that you briefly stop pedaling when changing gear.
This will aid the gear change and reduces wear on the
powertrain.
By selecting the correct gear, you can increase your
speed and range while applying the same amount of
force.
For this reason, follow the gear change recommenda-
tions provided by the indicators (g) and (h) on your
display. If indicator (g) is displayed, you should
(9)
(10)
(11)
Bosch eBike Systems