Switching On/Shutting Down The On-Board Computer; Battery Charge Indicator - Bosch Intuvia Instrucciones De Servicio

the USB port of a computer (5 V charging voltage,
max. 500 mA charging current). <USB connected>
will appear on the text indicator (d) of the on-board
computer.
(h)
(g)
(f)
(e)
Powering external devices from the USB
port
The USB port can be used to operate or charge most
devices that can be powered via USB (e.g. various
mobile phones).
Charging requires the on-board computer to be
mounted and a sufficiently charged battery to be in-
serted in the eBike.
Open the protective cap (8) for the USB port on the
on-board computer. Use a Micro-A – Micro-B USB
charging cable (available from your Bosch eBike
dealer) to connect the USB port on the external de-
vice to the USB port (7) on the on-board computer.
Once the electrical load has been disconnected, the
USB port must be carefully resealed with the protec-
tive cap (8).
A USB connection is not a watertight plug connec-
tion. When cycling in wet conditions, ensure no
external devices are connected and that the USB
port is fully covered by the protective cap (8).
Attention: Any electrical devices connected can re-
duce the range of the eBike.
Switching on/shutting down the on-board
computer
To switch on the on-board computer, briefly press
the on/off button (5). The on-board computer can
also be switched on when it is not inserted in the
holder (if the internal battery is sufficiently charged).
Bosch eBike Systems
(i)
(a)
TURBO
SPORT
TOUR
(b)
ECO
OFF
(c)
MPH
KM/H
AMM
PMWH
MIN
MPH
KM/H
(d)
Range
To switch off the on-board computer, press the on/
off button (5).
If the on-board computer is not inserted in the holder,
it automatically switches off after 1 minute to save en-
ergy if no button is pressed.
If you are not going to be using your eBike for
u
several weeks, remove the on-board computer
from its holder. Store the on-board computer in a
dry environment at room temperature. Regularly
recharge the on-board computer's battery (at least
every 3 months).

Battery charge indicator

The battery charge indicator (i) displays the state of
charge of the eBike battery, not that of the on-board
computer's internal battery. The state of charge of the
eBike battery can also be checked on the LEDs of the
battery itself.
Each bar of the battery symbol on the indicator (i)
represents approximately 20 % of the capacity:
The eBike battery is fully charged.
The eBike battery should be recharged.
The LEDs of the battery charge indicator
on the battery go out. The capacity for as-
sisting the drive has been used up, and as-
sistance is gently switched off. The re-
maining capacity is made available for the
lighting and the on-board computer. The
indicator flashes. The capacity of the
eBike battery is enough for about two
hours of lighting. This does not account
for other consumers (e.g. automatic gear-
box, charging external devices from the
USB port).
If the on-board computer is removed from the holder
(4), the last displayed state of charge of the battery is
saved. If an eBike is powered by two batteries, the
battery charge indicator (i) displays the state of
charge of both batteries.
English – 9
1 270 U20 XBI | (07.04.2020)