cozze 90354 Manual De Usuario página 10

INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your pizza oven and
causing injury to yourself and to property.
1. Assemble the pizza oven by following the assembly instructions carefully.
2. Connect the gas hose to the pizza oven. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions
supplied with the regulator.
4. Turn all of the control knobs to the 'OFF' position before turning on the gas supply to
the appliance.
5. Operate the regulator in accordance with the instructions supplied with the
regulator.
LIGHTING YOUR PIZZA OVEN
1. Connect the gas cylinder to the pizza oven following the instructions supplied with
the regulator.
2. Turn the control knob to the 'OFF' position.
3. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check the cylinder to regulator connection and
hose to pizza oven hose inlet connection for leakage using soapy water. Any leakage
will show as bubbles in the area of the leak. If leak is found, do not use the pizza oven.
Consult your gas or pizza oven supplier for advice.
4. To light the burner, push down the control knob and keep pressing whilst turning
anti-clockwise to the "Full rate" position and press the ignition button. This will light the
burner. Check that the burner is alight. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes
before retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by push down and turn the
knob anti-clockwise to any position between the full and low rate position.
7. After the oven is heated for use, the temperature should be turned down during
baking. The oven emits a lot of heat, and the temperature must therefore be adjusted to
the correct baking temperature.
8. To turn 'OFF' the pizza oven, turn the cylinder valve handle or regulator switch to
the 'OFF' position by following the regulator instructions. Once the burners have
extinguished turn all the control knobs to the 'OFF' position.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also
turn the cylinder valve off. Wait five minutes before attempting to relight with ignition
sequence. Or change the AA batteries.
After use, close the gas supply by either turning 'OFF' the switch on the regulator or
turning 'OFF' the cylinder valve.
In the event of light back whilst the appliance is in use. Turn the control, cylinder valve
10