Jeep JAT Manual De Uso página 15

FRONT WHEEL INSTALLATION
Rotate the fork until it is positioned in front of the frame and, after removing the front brake
caliper pad spacer, insert the front wheel into the dedicated fork housings (dropouts) and tighten
using the special quick-release device that can be found in the accessory box supplied with the
product.
Insert the pin with its conical spring inside the hub, leaving the lever on the left side of the bike (on
the brake disc side); insert the second conical spring and locking nut into the pin coming out of the
hub on the opposite side, screwing it in until it stops against the dropout.
Close the lever towards the fork to complete the tightening operation by verifying that the lever
has adequate resistance during the closing phase (such as to leave a mark on the palm of
the hand used to tighten the lever, so-called "imprint on palm") and, after closing, requires a
considerable force to be exerted to allow relative opening.
CAUTION
Do not operate the front brake lever (located on the left side of the handlebars) with the front
wheel not installed and the front brake caliper pad spacer missing.
Locking nut Pin
Conical springs*
*Conical springs: position the end of the conical
springs (those with the smallest diameter) in the
direction of the wheel.
14
Lever