Jeep JAT Manual De Uso página 17

DROPPER SEATPOST ADJUSTMENT
Before adjusting the saddle height, completely extend the dropper seatpost proceed as follows:
• place your right thumb on the dropper seatpost control lever (fig.E) and your left hand on the
saddle (fig.F);
• press the dropper seatpost remote control lever while using your left hand to control the
upward motion of the saddle up to the complete extension of the seat post.
Loosen the quick-clamping seat post clamping mechanism (quick-release seat post collar),
which secures the seat post to the frame's seat tube, allowing the seat post to be pulled out and/
or inserted until the desired saddle height has been achieved, taking care to make sure that the
saddle is aligned with the centre line of the bike frame.
Complete the operation by tightening the seat post collar to ensure that the seat post is secured to
the frame's seat tube.
DANGER
Minimum seat post insertion limit
It is strictly forbidden to pull the seat post out of the frame's seat tube beyond the minimum
insertion level indicated on the seat post itself, to avoid the risk of causing structural damage to
the bike (frame and/or seat post) and serious injuries.
The seat post is deemed to be correctly and safely positioned inside the seat tube of the frame by
inserting it so that no markings and/or graphic indication of the minimum insertion limit can be
seen; see:
fig.E
Correct position
Incorrect position
16
fig.F