TRAPP ES-500 Manual De Instrucciones página 38

Stretch the belt with the stretching screw (D).

Retighten the 4 screws (C) that secure the

transmission box.
Replace the belt protection (B).

Image
merely
illustrative
C
D
Figure 9
The outlet spout can adjust the direction of the
outlet device (C) and the rotation of 360°, in order
to make the adjustment, follow these directions
according to Figure 10:
The outlet device (C) direction is regulated by
the lever (A) releasing the knob (D). The spout (E)
position is adjusted through the arm (B), turn it
according to the direction in which you want to
pour the material. In order to avoid clogging of the
material outlet spout, do not tilt the outlet device
too much and do not use wet material.
38
B
A
Adjusting the Ration Outlet Device
Adjusting length of cut
Box pulley
ES-500 and ES-600
5 mm
10 mm
ES-550 and ES-650
4 mm
6 mm
8 mm
12 mm
E
B A
Figure 10
www.trapp.com.br
Cutting disk pulley
C
D
Image merely illustrative