Migatronic FLEX 3000 Duo Manual De Instrucciones página 16

PRODUCT PROGRAMME
FLEX 3000 Duo:
Welding machine for MIG/MAG welding with built-in
wire feeding.
Welding torches, hoses and cables
MIGATRONIC's standard product range can provide
MIG/MAG torches and hoses, return current cables
and wear parts etc.
®
MIG Manager (option)
FLEX 3000 Duo can be supplied with an advanced
torch, the MIG Manager
solution).
Torch cooling (option)
A torch-cooling unit is delivered standard to the
power source, which enables both gas-cooled and
water-cooled welding torches to be used.
Trolley (option)
FLEX 3000 Duo can be delivered with a trolley for
transport of the machine.
Gas adjustment kit (option)
FLEX 3000 Duo can be equipped with a gas
adjustment kit, which automatically enables the
machine to control the gas pressure.
Push pull (option)
MIGATRONIC push pull equipment and torch
assembly can be fitted to the machine on delivery or
as a retrofit.
MigaCARD
All welding machines are delivered with 1 MigaCARD
of standard type. This card contains both welding
programs and machine
MigaCARD can be bought as an editable card that
enables production of your own unique program
cards (option).
MIGATRONIC constantly increases the selection of
welding programs for FLEX 3000 Duo.
Trolley with unit for changable voltage (option)
A trolley with a built-in unit which automatically
adjusts the actual three-phased mains voltage (230-
500 V) to the FLEX 3000 Duo.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee
®
, as special equipment (kit
software.
CONNECTION AND OPERATION
Permissible installation
The following sections describe how the machine is
made ready for use and then connected to mains
supply, gas supply etc. The numbers in parentheses
refer to the illustrations in this paragraph.
Lift instructions
The lifting points must be used
(please see figure) when lifting the
machine. The machine must not be
lifted with mounted gas bottle.
Mains connection
Before connecting the power source to the mains
supply, ensure that the power source is of the same
voltage as the mains voltage provided and that the
fuse in the mains supply is of the correct size. The
mains cable (1) of the power source must be
connected to the correct three-phase alternating
current (AC) supply of 50 Hz or 60 Hz and with earth
connection. The sequence of the phases is not of
significance. The power source is switched on with the
mains switch (2).
Configuration
MIGATRONIC disclaims all responsibility for
damaged cables and other damages related to
welding with under sized welding torch and
welding cables measured by welding specifi-
cations e.g. in relation to permissible load.
Important!
In order to avoid destruction of plugs
and cables, good electric contact is
required when connecting earth
cable and welding torch to the
machine.
Warning
Connection to generators can damage the welding
machine.
When connected to a welding machine, generators
can produce large voltage pulses, which can damage
the welding machine. Use only frequency and voltage
stable generators of the asynchronous type.
Defects on the welding machine arisen due to
connection of a generator are not included in the
guarantee.
Connection of shielding gas
The shielding gas hose is fitted to the back panel of
the power source (3) and is connected to a gas supply
with a pressure reducton to 2-6 bar (with a gas
adjustment kit mounted). A gas cylinder can be
mounted on the bottle carrier on the back of the
trolley.
16