Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 14

Step 8
å
First, fasten the INNER SKIRT (FF) to the CENTER SKIRT (S). Use
three SILVER 1-5/8" FLAT HEAD SCREWS (152S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Next, fill the holes in the OUTER SKIRT (R) 1/4 to 1/2 full with
GLUE (177M). Then, insert the WOOD DOWELS (15F) into the
holes. Wipe away the excess GLUE.
å
Now, fill the holes in the END SUPPORT BOTTOM MOLDING (EE)
1/4 to 1/2 full with GLUE. Then, insert the WOOD DOWELS in the
OUTER SKIRT (R) into these holes. Wipe away the excess GLUE.
15F
The hole
is closer to
this edge.
Page 14
R
S
EE
427807
Fill the holes 1/4 to 1/2 full with GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely difficult.
SILVER 1-5/8" FLAT HEAD SCREW
(3 used in this step)
FF
www.sauder.com/commercial-office/service
177M
152S