Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 21

Step 15
å
Fasten one LONG TOP MOLDING (AA) to the LONG TOP (F). Use three SILVER 1-5/8" FLAT HEAD SCREWS (152S).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Turn the two LOCK MECHANISMS inside the LEFT PEDESTAL toward each other until they stop moving.
å
Turn the LOCK MECHANISM behind the LONG TOP MOLDING (AA) toward the DRAWERS until it stops moving.
The angled edge
should be toward the
inside of your unit.
LEFT PEDESTAL
www.sauder.com/commercial-office/service
F
AA
The LOCK MECHANISMS
will face each other when
locked in place.
This edge will be snug
against the front BRACE
on the LEFT PEDESTAL.
427807
The LOCK MECHANISM will
face toward the DRAWERS
when locked in place.
152S
SILVER 1-5/8" FLAT HEAD SCREW
(3 used in this step)
Page 21