Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 12

Step 6
å
Fasten the END SUPPPORT BOTTOM MOLDING (EE) to
the END SUPPORT (X). Use three BLACK 1-15/16" FLAT
HEAD SCREWS (113S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
These holes must be here.
Page 12
EE
X
The large holes
must be here.
427807
BLACK 1-15/16" FLAT HEAD SCREW
(3 used in this step)
Meet Part (X). This component has
been engineered to be lighter, stronger,
faster... well ok. Not technically faster.
But definitely makes for a sturdier
L-Desk that' s easier to assemble and
friendlier to the environment.
www.sauder.com/commercial-office/service
113S