Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 7

Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to
avoid scratching your unit or the floor. Save some packing material for
support to be used later in assembly.
å
Place the WASHER (82S) into one of the MOLDING CONNECTOR
CLIPS (173M) as shown in the enlarged diagram. Using your hammer,
gently tap on the WASHER to insert the MOLDING CONNECTOR CLIP
into the hole in the LONG MODESTY PANEL (H).
å
Repeat this method to insert the MOLDING CONNECTOR CLIPS (173M)
into the LONG MODESTY PANEL (H).
å
Line up the groove in the LONG MODESTY PANEL MOLDING (Y) over
the MOLDING CONNECTOR CLIPS in the MODESTY PANEL (H) and
snap the MOLDING onto the CLIPS.
å
NOTE: The MOLDING should be centered on the PANEL.
The groove
is closer to
this edge.
www.sauder.com/commercial-office/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
H
173M
Use your hammer to tap the WASHER (82S)
into the MOLDING CONNECTOR CLIP (173M).
82S
Be sure the MOLDING
CONNECTOR CLIP is
parallel to this edge.
H
427807
0
Pro Tip: You will need
someone's help later
in assembly.
173M
Y
Page 7