Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 18

Step 12
å
Fasten the END SUPPORT TOP MOLDING (N) to the LONG
TOP (F). Use three SILVER 1-5/8" FLAT HEAD SCREWS (152S).
å
Fasten two TOP BRACES (Q) to the LONG TOP (F). Use eight
SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
NOTE: The angled edge of the BRACE should face down and
toward the back edge of the TOP.
152S
SILVER 1-5/8" FLAT HEAD SCREW
(3 used in this step)
N
These holes are
closer to this edge.
Page 18
Back edge
Q
F
427807
10S
SILVER 1-1/8" FLAT HEAD SCREW
(8 used in this step)
Q
www.sauder.com/commercial-office/service
Angled edge