Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 15

Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 9
å
Turn three CAM SCREWS (8F) into the END SUPPORT (X).
å
Push two SAUDER TWIST-LOCK® FASTENERS (37F) into
the large holes in the END SUPPORT (X).
Do not tighten the TWIST-LOCK® FASTENERS in this step.
www.sauder.com/commercial-office/service
FASTENER
®
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
X
427807
Dowel end
1 2
8F
1
2
37F
Page 15