Sauder worksense MASON PEAK Serie Instrucciones De Montaje página 23

Step 17
å
Place the WASHER (82S) into one of the MOLDING CONNECTOR CLIPS (173M) as shown in the enlarged diagram.
Using your hammer, gently tap on the WASHER to insert the MOLDING CONNECTOR CLIP into the hole in the SHORT
MODESTY PANEL (Z).
å
Repeat this method to insert the MOLDING CONNECTOR CLIPS (173M) into the SHORT MODESTY PANEL (Z).
å
Line up the groove in the SHORT MODESTY PANEL MOLDING (U) over the MOLDING CONNECTOR CLIPS in the
SHORT MODESTY PANEL (Z) and snap the MOLDING onto the CLIPS.
www.sauder.com/commercial-office/service
Z
U
Z
427807
Use your hammer to tap the WASHER (82S)
into the MOLDING CONNECTOR CLIP (173M).
82S
173M
173M
These edges must be even.
Be sure the MOLDING
CONNECTOR CLIP is
parallel to this edge.
U
The groove
is closer to
this edge.
Page 23