Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly instructions
Original parking distance control, Audi A3 2004 ➤
Set Contents:
◆
1 x controller
◆
1 x buzzer
◆
4 x sensors
◆
4 x protective rings
◆
1 x fixing material
Special tools, test and measuring equipment, and ancillaries required:
◆
Flat-tip screwdriver
◆
Phillips screwdriver
◆
Side cutters
◆
Hand drill
◆
Set of twist drills
Forstner bit ∅ 20 mm
◆
◆
Triangular file
1
Procedure:
Note
◆
The original parking distance control should be fitted by a competent workshop. Incorrect fitting may lead to
damage to the vehicle or the parking distance control.
◆
The work to be performed described in these fitting instructions may change due to model servicing schedules.
For example, changes to the wiring colours or even the fitting sites should not be discounted. For this reason,
always consult the relevant up-to-date wiring diagram or the current vehicle repair manual.
◆
All rights to make technical changes reserved.
1.1
Painting sensors
Note
◆
The sensor only require painting in the car colour when the bumpers are painted. In the bumpers are not painted,
the sensors do not require painting.
◆
Do not clean the sensors prior to painting with a silicone remover, but use a mild alcohol, e.g. methylated spirit
◆
Leave the sensors for painting in the packaging supplied, this is provided as a painting device.
◆
Additional general information on the topic of painting:
⇒
Self-study programme No. 214/215
Page 1 - Fig. 1
The figure gives an example of the protective rings -1- already placed in the correct position on the sensors -4-.
−
Place the protective rings -2- on the rubber membranes of the sensors -3-.
−
Paint the sensors -3- and -4- evenly, and not too thickly, in the same colour as the car.
−
Remove the protective rings -1- and -2- carefully directly after painting (while the paint is still wet) using tweezers
and let the paint dry.
Note
The protective rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.
−
Repaint as necessary after drying (e.g. clear lacquer for twin coat painting).
Mark and drill the sensor fitting holes, vehicles 2004 ➤ 2008 and S3 2009 ➤
1.2
Page 2 - Fig. 2, 3, 4
−
To simplify marking and protect the bumper covering, apply tape generously to the areas to be drilled as in the
dimensioning instructions.
◆
Figure 1: 3- and 5-door vehicles without S-Line/S3 equipment -A- and -B-
◆
Figure 2: 3-door vehicles with S-Line/S3 equipment -C-
◆
Figure 3: 5-door vehicles with S-Line/S3 equipment -D-
−
Cover the centre of the bumper covering with tape to simplify marking.
−
Mark the centre line of the vehicle on the adhesive tape, e.g. starting from the tailgate.
*please refer to the set contents
◆
1 x power harness
◆
1 x sensor harness
◆
1 x assembly instructions
◆
1 x operation manual
◆
Pencil
◆
Measuring and cutting tool
◆
Marker bit
◆
Round file
◆
Tweezers
◆
Scissors
◆
-VAS 1978- harness repair set
8P7 054 630
25
Publicidad
