Audi 8P7 054 630 Instrucciones De Montaje página 29

−
Switch on the ignition and engage reverse gear.
The controller signals the start of the learning process with a double beep.
If there is no beep after engaging reverse gear, look for a fault.
⇒
1.8 Setup troubleshooting
A single long tone must sound within a maximum of 100 seconds - this tone denotes that the learning process has
been completed successfully.
If the learning process is not confirmed as complete within 100 seconds, you must look for a fault.
⇒
1.8 Setup troubleshooting
−
After the successfully completed learning process is signalled audibly, and the ignition switched off, cut the blue
loop wire from the power harness.
−
Isolate the ends of the cut blue wire.
This ends the setting up process.
−
Check the parking distance control system functions using the enclosed operating instructions.
If all the parking distance control system functions are in order, complete final fitting.
⇒
1.9 Final fitting
Establish the parking distance control fault functions - carry out troubleshooting and then set up again.
⇒
1.8 Setup troubleshooting
Note
The new setup can take place after the cut blue wire is reconnected.
1.8 Setup troubleshooting
Note
If the fault has been found and rectified, the parking distance controller must be set up again.
⇒
1.7 Setting up the parking distance control system
If there is no tone after switching on the ignition and engaging reverse gear, check the power supply, connections to
the controller and the reversing light bulb.
Note
If the reversing light bulb is defective, the power is cut off by the control unit. A fault is indicated in the instrument
panel inset. In this case, the parking distance control system does not work.
Page 8 - figure 1
With reverse gear engaged, is the supply voltage to connector -2- 12V?
⇒
Fault diagnosis as per the wiring diagram
Is the buzzer connector -4- connected correctly?
Is the blue wire from the power harness cut or still intact? If necessary, remake the connection.
If a single long tone does not sound after the double beep (start of the learning process) within a max. of 100 sec-
onds, check the sensor connections.
If a single long tone does not sound after the double beep (start of the learning process) within a max. of 100 sec-
onds, but an intermittent beep is heard instead, then the obstacle behind the car has not been detected.
⇒
Check the distance from the wall, correct as necessary, or align with another obstruction at a distance of 50 cm.
1.9 Final fitting
Page 9 - Fig. 1
−
Wrap the controller in self-adhesive tape* -1-.
Page 9 - Fig. 2
−
Locate the wrapped controller -2- between the vehicle holder -1- and the bodywork.
−
Secure all the parking distance controller harness to existing vehicle harness or holders to avoid noises.
−
Fit the tailgate light cluster (only 2-door hatchbacks) and all trims in reverse order.
⇒
Electrical system; Repair Group 94; exterior lights, lamps and switches
⇒
Interior bodywork fitting; Repair Group 68; interior fittings
*please refer to the set contents
29