Toro TimeCutter 34 Manual Del Operador página 29

1. If you are using a trailer, connect it to the towing
vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes and
lights.
3. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees
4. Back the machine up the ramp
1. Back the machine up the
ramp.
5. Shut off the engine, remove the key, and move
the motion-control levers outward to the P
position.
6. Tie down the machine near the front caster
wheels and the rear frame with straps, chains,
cable, or ropes (Figure
regulations for tie-down requirements.
1. Tie-down points
Unloading the Machine
1. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees
2. Drive the machine forward down the ramp
(Figure 27).
(Figure 26).
(Figure
Figure 27
2. Drive the machine forward
down the ramp.
28). Refer to local
Figure 28
(Figure 26).
27).
g027995
ARK
g027708
27