Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure
65).
Figure 65
1. Front support rod
5.
Carefully lower the front of the mower deck to
the ground.
6.
On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin
Figure 66
1. Lift arm
2. Hairpin cotter
g366001
2. Deck bracket
(Figure
66).
g295768
3. Washer
7.
Remove the lift arm from the deck pin
66).
8.
Repeat steps
machine.
9.
Slide the mower deck rearward to remove the
mower belt from the engine pulley.
10.
Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower Deck
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest
position.
5.
On 1 side of the machine, lift the rear of the
mower deck and install the lift arm to the deck
pin
(Figure
66).
6.
Install the lift arm using the washer and hairpin
cotter
(Figure
7.
Repeat steps
machine.
8.
Attach the front support rod to the mower deck
with the clevis pin and hairpin cotter
9.
Install the mower belt onto the engine pulley;
refer to
Replacing the Mower Belt (page
Replacing the Grass
Deflector
Service Interval: Before each use or daily—Inspect
the grass deflector for damage.
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
Never operate the machine unless you install
a mulch plate, discharge deflector, or grass
collection system.
45
6
and
7
for the other side of the
66).
5
and
6
for the other side of the
(Figure
ARK
(Figure
65).
39).
Publicidad
